2.23inch OLED display HAT for Raspberry Pi, 128×32 pixels, SPI/I2C interface
This is an OLED display HAT for Raspberry Pi, 2.23inch diagonal, 128×32 pixels, with embedded SSD1305 driver, communicating via SPI or I2C interface.
Trying to add a control interface for your Pi? This compact display would be the ideal choice.
- Driver: SSD1305
- Interface: SPI / I2C
- Display size: 2.23inch diagonal
- Display color: white
- Resolution: 128×32
- Viewing angle: >160°
- Power supply voltage: 3.3V/5V
- Logic level: 3.3V
- VCC:3V3/5V-Power input
- DIN:MOSI-SPI data input
- CLK:SCLK-SPI clock input
- CS:CE0-Chip selection, low active
- DC:P24-Data/Command selection (high for data, low for command)
- RST:P25-Reset, low active
- 2.23inch OLED HAT x1
- RPi screws pack (2pcs) x1
1.The interface of 2.23inch OLED HAT is default SPI interface, that is 0R resistors are soldered to SPI sides. If you want to use I2C interface, you need to solder the 0R resistors to I2C side
2.If you need more resources , please contact us via Amazon message to receive the document
Make sure this fits by entering your model number.
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
Optional interfaces: SPI (default), or I2C, configured via onboard resistor
Brings control pins Compatible with host boards like Arduino/STM32
Comes with development resources and manual (examples Compatible with Raspberry Pi/Jetson Nano/Arduino/STM32)
Technical Support is provided , please contact us if you have any problem , we will reply you soon.