BN-220 GNSS GLONASS Dual GPS Module Antenna Built-in LED Flash TTL Level 9600bps 4M

Amazon.com Price: $16.88 (as of 02/06/2020 06:30 PST- Details)

BN-220 has flash to save configuration, so you do not need to reset data next time when you use it
When you use it for Raspberry Pi, there is no driver needed but you need to install software
The data output when the TX LED flashing in blue; PPS LED not bright when GPS not fixed, flashing in red when fixed

Compare
Category:

Description


Features:
Dimension: 22mm*20mm*6mm
Weight: 5.3g
Connector: 1.00mm spacing between the 4pins patch seat

Specification
Chipset: M8030-KT
Receiving Format: GPS, GLONASS, Galileo, BeiDou, QZSS and SBAS
Frequency: GPS L1,GLONASS L1,BeiDou B1,SBAS L1,Galileo E1
Channels: 72 Searching Channel

Sensitivity
Tracking: -167dBm
Reacquisition: -160dBm
Cold start: -148dBm
Hot start: -156dBm

Accuracy
Position Horizontal: 2.0 m CEP 2D RMS SBAS Enable (Typical Open Sky)
Velocity: 0.1m/sec 95% (SA off)
Timing: 1us synchronized to GPS time
Acquisition Time
Cold Start: 26s
Warm start: 25s
Hot start: 1s

Data output
Support Rate: 4800bps to 921600bps,Default 9600bps
Data Level: TTL or RS-232,Default TTL level
Data Protocol: NMEA-0183 or UBX, Default NMEA-0183
Single GNSS: 1Hz-18Hz
Concurrent GNSS: 1Hz-10Hz,Default 1Hz

Operational Limits
Altitude: 50,000m Max
Velocity: 515m/s Max
Acceleration: Less than 4g

Power consumption
VCC: DC Voltage 3.0V-5.5V,Typical: 5.0V
Current: Capture 50mA/5.0V
Operating temp: -40 °C ~ +85°C
Storage Temp: -40°C ~ +105°C

Indicator:
TX LED: blue. The data output, TX LED flashing
PPS LED: red.PPS LED not bright when GPS not fixed, flashing when fixed
Wiring:
PIN GND: Ground
PIN TX: Serial Data Output
PIN RX: Serial Data Input
PIN VCC: DC 3.0V-5.5V supply input, Typical: 5.0V

Packaging List
1 x BN-220 GPS Module
2 x 15cm Cable

BN-220 has flash to save configuration, so you do not need to reset data next time when you use it
When you use it for Raspberry Pi, there is no driver needed but you need to install software
The data output when the TX LED flashing in blue; PPS LED not bright when GPS not fixed, flashing in red when fixed
Data Level: TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
Great Accuracy: 2.0 m CEP 2D RMS SBAS Enable (Typical Open Sky) at Position Horizontal, 0.1m/sec 95% (SA off) at Velocity, 1us synchronized to GPS time at Timing

Additional information

Item Weight

Package Dimensions

Brand