PChero L298N Motor Drive Controller Board Module, Dual H Bridge DC Stepper For Arduino Smart Car Robot

Amazon.com Price: $6.49 (as of 06/05/2020 13:05 PST- Details)

Make sure this fits by entering your model number.
★ Package Included – 1pcs L298N Motor Driver Controller Board Modules.
★ Item Size – External size 43*43*27mm / 1.69*1.69*1.06 inch. Drive voltage 5V-35V, high working power to 46V. Large current can reach 3A MAX and continue current is 2A. Power to 25w.(NOTE: To avoid damage, please use an external 5V logic supply when using more than 12V driving voltage.)

Compare

Description

Size:1 Pack

Why CHOOSE PChero Motor Drive Controller Board Moduld?

Reason 1: Use L298N for Main Chip

L298N is a kind of high voltage, high current motor driver chip. Having 15 pins as package, this chip has such features as high working voltage(maximum voltage up to 46V),large output current(instantaneous peak current up to 3A, continuous working current 2A) and 25W of rated power. Two built-in H birdge high voltage and large current full bridge drivers can be used to drive the DC motor and stepper motor, relay coil and so on.Using standard logic level signal control, it has two enable control ends. It permits or prohibites device having a logic power supply input without the impact of input signal, which enables the internal logic circuit part works at low voltage. The chip can connects to external detecting resistor to give the variations to the control circuit. Using L298N chip to drive the motor, this chip can drive a stepping motor or four phase stepping motor, and two DC motors as well.

Reason 2: Wide Application

PChero L298N Motor Drive Controller Board Mould is ideal for Arduino, Smart Car, Power UNO, MEGA R3, Mega 2560, etc.

Specification –

Chip: L298N

Logic voltage: 5V

Logic current 0mA-36mA

Maximum power: 25W

Drive voltage: 5V-35V

Drive current: 2A(For each DC motor)

Dimension: 43*43*27mm/ 1.69*1.69*1.06 inch

Operating mode: Dual H-bridge driver (can drive 2 DC motors)

Attention –

This module has a built-in 5V power supply, when the driving voltage is 7V-35V, this supply is suitable for power supply.

If driving voltage is more than 12V, please use external 5 Volt logic outputs to switch the H-bridge circuits.

DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available.

Package Included –

1 x L298N Motor Drive Controller Board Module

Make sure this fits by entering your model number.
★ Package Included – 1pcs L298N Motor Driver Controller Board Modules.
★ Item Size – External size 43*43*27mm / 1.69*1.69*1.06 inch. Drive voltage 5V-35V, high working power to 46V. Large current can reach 3A MAX and continue current is 2A. Power to 25w.(NOTE: To avoid damage, please use an external 5V logic supply when using more than 12V driving voltage.)
★ High Quality – Use L298N as the main driving chip, so the module has such features as strong driving ability, strong anti-interference and low calorific value. And it also use large-capacity filter capacitor and diode with freewheeling protection function, thereby improve the reliability of module.
★ High Efficiency – Dual-channel H-bridge design, can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors.
★ Easy of Use – No assembly required. This L298N board comes ready to go. Just wire up motors and power, this thing will work wonders.

Additional information

Size

Brand